Home / server / Questions / 118076
Accepted
pplrppl
Asked: 2010-03-02 14:09:38 +0800 CST

Is there a way to configure a job in Backup Exec 12.5 to eject a tape at a certain time no matter what

  • 772

I know I can have a backup job eject a tape after a job completes. I have Differentials going to a single tape mulitple days per week. Is there any way to create a job just to eject a tape without writing new data or is my only option to create a new backup job set to backup some small file and use the eject tape at end option?

I'm concerned if the dummy backup fails due to a full tape, write protected tape, etcetera that Backup Exec will just consider the job failed and not eject the tape as failed doesn't equal completed.

So either positive answer would be good.

  1. a method to eject the tape on schedule no matter what
  2. a dummy backup job would eject the tape even if the backup "fails"

TonyUser has given me a way to do 1. I'm afraid 2 might not be possible. Assuming no better answer is given I'll just leave a scheduled task to run weekly doing "c:\program files\Symantec\Backup Exec\bemcmd" -o115 -d"HP 1"

lto-3 backupexec

2 Answers

  1. Best Answer

    How about running the command line tool BEMCMD as a scheduled task:

    for Backup Exec 11.x and above
    c:\program files\Symantec\Backup Exec\bemcmd -o115 -d"HP 1"`
    where C: is the drive where Backup Exec has been installed
    -o115 is for creating an eject job
    HP 1 is the device name

    Or RMS might also work.

    • 2

  2. If you are trying to export a specific slot, you can set a schedule for an Export job to run. In the Slots listing in the Device tab you can right-click on a slot and set this up.

    • 0