Home / server / Questions / 985445
In Process
16851556
Asked: 2019-09-25 04:16:09 +0800 CST

How to allow Linux networking into the internet on Hetzner cloud server while the routing table contains only 169.254.0.0 IP?

  • 772

i am having virtual server from Hetzner and after installing the CentOS 6 linux, i do not know how to make the default installation available from the internet, how to setup the routing. The Hetzner says that the gateway IP should be 172.31.1.1 (https://wiki.hetzner.de/index.php/CloudServer/en#What_are_Routes.3F - "The special private IP Address 172.31.1.1. This IP address is being used as a default gateway of your servers public network interface. ")

At first following worked: /sbin/route add default gw 172.31.1.1 eth0

but now one day later it says SDIOCADDRT: Network is unreachable. Current routing table (route -n) contains only one rule: 169.254.0.0/16 dev eth0 scope link metric 1002

Config file for the eth0 interface is: https://i.postimg.cc/9Qc6VwK7/ifcfg-eth0.gif

Please can you tell me which commands should make the routing table be done properly? Or what is wrong in my eth0 interface config. file?

UPDATE: i was told i should use static configuration on CentOS 6, but i am having problem with the route-eth0 file as i am unable to create it:

cp /etc/host.conf /etc/sysconfig/network-scripts/route-eth0 perl -pi -e s/multi on/172\.31\.1\.1\/32 dev eth0\\ndefault via 172\.31\.1\.1 dev eth0/g /etc/sysconfig/network-scripts/route-eth0

The error is: Substitution pattern not terminated at -e line 1.

(i can not use echo or tee or vim because Hetzner console do not work with | " ' $ > characters and Ctrl key)

networking

1 Answers

  1. They told me i need to use static configuration and it worked (after restarting network / rebooting).

    (Note that the IPs under that link are likely specific only to a Hetzner servers)

    Adjusting the configuration files was very difficult via Hetzner console (which does not accept Ctrl key, | > $ " ' etc.).

    These were the commands i had to run (will almost certainly work only on Hetzner + CentOS 6 and after replacing myvpspubliciphere. But can give idea for anyone using limitted web console like one from Hetzner):

    perl -pi -e s/BOOTPROTO=dhcp/BOOTPROTO=static/g /etc/sysconfig/network-scripts/ifcfg-eth0
perl -pi -e s/IPV6INIT=no/IPADDR=myvpspubliciphere/g /etc/sysconfig/network-scripts/ifcfg-eth0
perl -pi -e s/ONBOOT=yes/ONBOOT=yes\\nNETMASK=255.255.255.255\\nDNS1=213.133.98.98\\nDNS2=213.133.99.99/g /etc/sysconfig/network-scripts/ifcfg-eth0
cp /etc/host.conf /etc/sysconfig/network-scripts/route-eth0
perl -pi -e s/multi\ on/172.31.1.1\\/32\ dev\ eth0\\ndefault\ via\ 172.31.1.1\ dev\ eth0/g /etc/sysconfig/network-scripts/route-eth0
service network restart

    (the cp command was used to get a small file with just a two words which i can use for easily replacing its content by what i needed)

    • 0